offset on channels
Offset on channels, a forum discussion on Cleverscope Mixed Signal USB Oscilloscopes. Join us for more discussions on Offset on channels on our Questions forum.
You must be logged in to post a reply
 Back to Forum Index : Back to Questions |
 |
Nickolas
9 Feb 2023
Posts: 9
Hello. I am having offsets on my channels, -10mV on chA and -20mV on B. Any way of fixing this? The probe tip is of course shorted to probe return clip.
thnks
thnks
Hi Nickolas,
Try running a Standard Calibration - after it has warmed up for a while
Another possibility is that you might be looking at a high frequency signal. If the probe compensation is incorrect, then the probe gain might not be right, and there will be an apparent offset. Use the probe comp output, with the BNC adaptor attached to the probe (in the probe accessory pack), and check the offset close to the trigger point - looking at the 0 volts part of the waveform, and adjust the probe comp screw on the probe for 0 volts.
Roger
Try running a Standard Calibration - after it has warmed up for a while
Another possibility is that you might be looking at a high frequency signal. If the probe compensation is incorrect, then the probe gain might not be right, and there will be an apparent offset. Use the probe comp output, with the BNC adaptor attached to the probe (in the probe accessory pack), and check the offset close to the trigger point - looking at the 0 volts part of the waveform, and adjust the probe comp screw on the probe for 0 volts.
Roger
[editor:html]
| Back to Forum Index : Back to Questions |
|