Family of Curves

You can use the 'AddRef' persistence command to make a family of curves, and then step around them, and make further measurements as needed.

This video shows you how to collect a family of Gain/Phase plots for a TI 5V 2.5A power supply, as the load current is varied from 2.5A to 1A and then 0.5A.

More from this section

BNC Fixture Calibration

In addition we can compensate for the open circuit capacitance of the fixture. This video shows you how to simply calibrate a fixture, and then shows you the results with three 0603 SMT capacitors.... > Read more

Output Impedance

This video shows you how to connect up a CS328A-FRA and measure the Output impedance of an LTC3589 over the frequency range 20 Hz - 1 MHz. > Read more


Your shopping cart is empty.