Triggering on Signalgenerator zero-transition
Triggering on Signalgenerator zero-transition, a forum discussion on Cleverscope Mixed Signal USB Oscilloscopes. Join us for more discussions on Triggering on Signalgenerator zero-transition on our Desired Features forum.
You must be logged in to post a reply
![]() |
![]() |
danriech
27 Oct 2007
Posts:
Hi there,
is it possible to trigger the Aquisition Unit on the SGs (f.e. sine) zero-transition without using the ext trig channel, just by internal sync of SG and AU? Or are these two units ""stand-alone""-modules just installed in the same housing? The reason for asking is the fact that frequency-response-measurement with the cleverscope are quite difficult to perform with the inaccuracies deriving from triggering with ext trig connected to the SG. I wish to get independent of the CAU-op-amp's rise-times.
Regards
Daniel
is it possible to trigger the Aquisition Unit on the SGs (f.e. sine) zero-transition without using the ext trig channel, just by internal sync of SG and AU? Or are these two units ""stand-alone""-modules just installed in the same housing? The reason for asking is the fact that frequency-response-measurement with the cleverscope are quite difficult to perform with the inaccuracies deriving from triggering with ext trig connected to the SG. I wish to get independent of the CAU-op-amp's rise-times.
Regards
Daniel
Hi Daniel,
If you use the ""sweep synchronous"" option for the SG then the frequency is only adjusted between sample frames.
Regards,
Roger
If you use the ""sweep synchronous"" option for the SG then the frequency is only adjusted between sample frames.
Regards,
Roger
[editor:html]
danriech
28 Oct 2007
Posts:
Thanks for your answer,
so it seems that there is some kind of communication between SG and AU, but is it possible to set the timebase of each captured frame to zero for the point of time when the SG has it's zero transition? AKA triggering on the discrete voltage the DDS is putting out (0V)?
Regards
daniel
so it seems that there is some kind of communication between SG and AU, but is it possible to set the timebase of each captured frame to zero for the point of time when the SG has it's zero transition? AKA triggering on the discrete voltage the DDS is putting out (0V)?
Regards
daniel
Hello daniel,
At the moment we do not have a facility to trigger on the zero crossing, as the signal is generated with a DDS chip quite independant of acquisition processor and logic. However, we do have control of the phase, so we could force the phase to 0, and start the frame at that point. However this would result in a discontinuity at the point at which we set the phase to 0.
At the moment we do not have a facility to trigger on the zero crossing, as the signal is generated with a DDS chip quite independant of acquisition processor and logic. However, we do have control of the phase, so we could force the phase to 0, and start the frame at that point. However this would result in a discontinuity at the point at which we set the phase to 0.
[editor:html]
Back to Forum Index : Back to Desired Features |
![]() |