Setting up the trigger
Setting up the trigger, a forum discussion on Cleverscope Mixed Signal USB Oscilloscopes. Join us for more discussions on Setting up the trigger on our Questions forum.
You must be logged in to post a reply
![]() |
![]() |
Dimensions
27 Oct 2010
Posts: 27
How would you set up to trigger on channel A after it has been at 5v for 2mS.
Thanks
Thanks
bartschroder
27 Oct 2010
Posts: 471
Hello Gary,
I am assuming you want to trigger on a high going pulse that lasts 2 ms, and it reaches at least 5V.
1. For this simple case, use View/Display Trigger 2 Settings, and make sure 'Trigger 1 inverted' is selected as the Trigger 2 source.
2. Set the Trigger 1 level to a useful threshold, eg 4.5V (it needs to be at least one minor division lower than the minumum high going voltage).
3. If you want to capture any high going pulse longer than 2ms, set the Trigger 1~2 Use to 'Trig 1~2 > max' on the control panel.
4. Set max to 2m.
That should do it.
If you wanted to trigger on pulses that were in the range 2ms to 2.5ms say:
3. Set the Trigger 1~2 Use to 'min < Trig 1~2 < max' on the control panel.
4. Set min to 2m and max to 2.5m
I hope this helps.
I am assuming you want to trigger on a high going pulse that lasts 2 ms, and it reaches at least 5V.
1. For this simple case, use View/Display Trigger 2 Settings, and make sure 'Trigger 1 inverted' is selected as the Trigger 2 source.
2. Set the Trigger 1 level to a useful threshold, eg 4.5V (it needs to be at least one minor division lower than the minumum high going voltage).
3. If you want to capture any high going pulse longer than 2ms, set the Trigger 1~2 Use to 'Trig 1~2 > max' on the control panel.
4. Set max to 2m.
That should do it.
If you wanted to trigger on pulses that were in the range 2ms to 2.5ms say:
3. Set the Trigger 1~2 Use to 'min < Trig 1~2 < max' on the control panel.
4. Set min to 2m and max to 2.5m
I hope this helps.
Back to Forum Index : Back to Questions |
![]() |