Minor v4631 issues
Minor v4631 issues, a forum discussion on Cleverscope Mixed Signal USB Oscilloscopes. Join us for more discussions on Minor v4631 issues on our Questions forum.
You must be logged in to post a reply
Back to Forum Index : Back to Questions |
AkkiSan
31 Oct 2008
Posts: 22
The brand new v4631 update, if used on my CS328 (non A),
causes a signal generator offset of ~+1V (without termination).
Downgrading to v4630 solves this problem.
Thank you very much for implementing ""The Log"" !-)
It would be very nice if you could add the ability of logging
the signal generator frequency too.
The ""internal"" frequency measurement (""Fundamental Frequency"" in
signal information, Scope/Tracker/Maths) is limited and can not
be used for large frequency spans.
Sometimes I am missing the possibilty of logging values from
different ""sources"".
E.g.: peak-peak or RMS from scope as well as f0, f1 from the
spectrum graph.
Axel
causes a signal generator offset of ~+1V (without termination).
Downgrading to v4630 solves this problem.
Thank you very much for implementing ""The Log"" !-)
It would be very nice if you could add the ability of logging
the signal generator frequency too.
The ""internal"" frequency measurement (""Fundamental Frequency"" in
signal information, Scope/Tracker/Maths) is limited and can not
be used for large frequency spans.
Sometimes I am missing the possibilty of logging values from
different ""sources"".
E.g.: peak-peak or RMS from scope as well as f0, f1 from the
spectrum graph.
Axel
[editor:html]
rhcarter
11 Nov 2008
Posts: 113
Axel,
v4631 includes a significant upgrade of the calibration system. Therefore, especially for the earlier units but beneficial for all, you should do a full calibration. This should resolve your problem.
The logging features are expanding all the time so it is likely that those will be added in time - I will add them to our route map.
Regards,
Roger Carter
v4631 includes a significant upgrade of the calibration system. Therefore, especially for the earlier units but beneficial for all, you should do a full calibration. This should resolve your problem.
The logging features are expanding all the time so it is likely that those will be added in time - I will add them to our route map.
Regards,
Roger Carter
[editor:html]
Back to Forum Index : Back to Questions |